AssociateConnectionWithLagResponse

Gets and sets the property AwsDevice.

The Direct Connect endpoint on which the physical connection terminates.

Gets and sets the property AwsDeviceV2.

The Direct Connect endpoint that terminates the physical connection.

Gets and sets the property AwsLogicalDeviceId.

The Direct Connect endpoint that terminates the logical connection. This device might be different than the device that terminates the physical connection.

Gets and sets the property Bandwidth.

The bandwidth of the connection.

Gets and sets the property ConnectionId.

The ID of the connection.

Gets and sets the property ConnectionName.

The name of the connection.

Gets and sets the property ConnectionState.

The state of the connection. The following are the possible values:

• ordering: The initial state of a hosted connection provisioned on an interconnect. The connection stays in the ordering state until the owner of the hosted connection confirms or declines the connection order.

• requested: The initial state of a standard connection. The connection stays in the requested state until the Letter of Authorization (LOA) is sent to the customer.

• pending: The connection has been approved and is being initialized.

• available: The network link is up and the connection is ready for use.

• down: The network link is down.

• deleting: The connection is being deleted.

• deleted: The connection has been deleted.

• rejected: A hosted connection in the ordering state enters the rejected state if it is deleted by the customer.

• unknown: The state of the connection is not available.

Gets and sets the property EncryptionMode.

The MAC Security (MACsec) connection encryption mode.

The valid values are no_encrypt, should_encrypt, and must_encrypt.

Gets and sets the property HasLogicalRedundancy.

Indicates whether the connection supports a secondary BGP peer in the same address family (IPv4/IPv6).

Gets and sets the property JumboFrameCapable.

Indicates whether jumbo frames are supported.

Gets and sets the property LagId.

The ID of the LAG.

Gets and sets the property LoaIssueTime.

The time of the most recent call to DescribeLoa for this connection.

Gets and sets the property Location.

The location of the connection.

Gets and sets the property MacSecCapable.

Indicates whether the connection supports MAC Security (MACsec).

Gets and sets the property MacSecKeys.

The MAC Security (MACsec) security keys associated with the connection.

Gets and sets the property OwnerAccount.

The ID of the Amazon Web Services account that owns the connection.

Gets and sets the property PartnerName.

The name of the Direct Connect service provider associated with the connection.

Gets and sets the property PortEncryptionStatus.

The MAC Security (MACsec) port link status of the connection.

The valid values are Encryption Up, which means that there is an active Connection Key Name, or Encryption Down.

Gets and sets the property ProviderName.

The name of the service provider associated with the connection.

Gets and sets the property Region.

The Amazon Web Services Region where the connection is located.

Gets and sets the property Tags.

The tags associated with the connection.

Gets and sets the property Vlan.

The ID of the VLAN.