Step C: Install the Conductor Live software

Perform these on the Conductor Live appliance, either directly at the appliance or from your workstation via SSH.

To install the Conductor Live software

1. At the Linux command line, log in with the elemental user credentials.

2. Run the installer with this command. Use the actual file name of your .run file rather than the example below.

   [elemental@hostname ~]$ sudo sh ./elemental_production_conductor_live247_3.25.4.12345.run -l -z -t

   where -l is a letter, not a number.

3. Follow the prompts:

   Prompt	Action
   Do you agree to these terms?	This prompt appears after you have paged through the EULA (End User License Agreement). Enter Yes or No. (You must enter Yes to continue.)
   Enter this server’s Hostname	Type the hostname of this appliance. For example, conductor-live-3-01
   Does eth0 use DHCP to get its IP address?	Type Yes to use DHCP or type No to enter a static IP address.
   Enter eth0's IP address:	If you chose static, type the IP address for this hardware unit.
   Enter eth0's NETMASK:	If you chose static, type the netmask for this hardware unit.
   Enter eth0's Gateway (or type none):	If you chose static, type none or type the gateway for this appliance.
   Keep this configured nameserver?	Skip; you set up a nameserver in the next phase of configuration.
   Would you like to configure eth1?	Type No; you can configure eth1 in the next phase of the configuration.
   The firewall for this system is currently disabled. Would you like to enable it?	Skip; you set up the firewall in the next phase of configuration.
   Would you like to start the Elemental service now?	Type Yes.

   Then the software is installed. Finally, this message appears:

   Installation and configuration complete!
   Please open a web browser and point it to https://xxx.xxx.xxx.xxx to get to the web interface.
   Enjoy!

4. Start a web browser and start the Conductor Live web interface by typing the following:

   https://<hostname>

   Make sure the web interface displays.