Add Ethernet Devices - AWS Elemental Live

This is version 2.18 of the AWS Elemental Live documentation. This is the latest version. For prior versions, see the Previous Versions section of AWS Elemental Live and AWS Elemental Statmux Documentation.

Add Ethernet Devices

When you installed AWS Elemental Live, you configured eth0. If you also set up eth1 at that time, no further configuration is required. If you didn't set up eth1 or want to set up more devices, use these instructions to do so.

To add Ethernet devices

  1. On the AWS Elemental Live web interface, go to the Settings page and choose Network.

  2. On the Network page, choose Network Devices.

  3. On the Network Devices page, choose Add Network Device.

  4. In the Add a New Network Device dialog, select eth (ethN).

  5. Complete the fields as follows:

    • Device Name: Select the eth device that you're setting up.

    • Address Mode: Select the type of IP addresses this device uses, either dhcp, static, or none. If you're bonding eth0 and eth1, use static IPs.

    • IP Address, Netmask, Gateway: Available when static IP addresses are used only. Complete with your networking information.

    • Static Routes: Select if you're using static routing.

    • Network, Netmask, Gateway: Available when static routes are used only. Complete with your networking information.

  6. Choose Save. The new device appears in the Network Devices list.