This is version 2.17 of the AWS Elemental Server documentation. This is the latest version. For prior versions, see the Previous Versions section of AWS Elemental Conductor File and AWS Elemental Server Documentation.
Still Image Inserter (Graphic Overlay) in AWS Elemental Server
The following procedure walks you through setting up a still graphic overlay. To begin, decide where in your job to specify the overlay. This choice affects how the overlay appears in outputs.
Note
One job can have any combination of input, stream, and global overlays. To set up multiple overlays, repeat this procedure.
To set up a still image overlay
-
Decide where in your job to specify the overlay.For information about how this choice affects how the overlay appears in the outputs, see Choosing Between Input, Stream, and Global Overlay.
-
Prepare your overlay file.For more information, see Overlay File Requirements and Sizing Your Overlay to Account for Scaling.
-
In the appropriate section of the job, choose the Image Inserter slider and then choose Add Image. Find the appropriate sections as follows:
-
Find the dark gray Input section at the top of the job.
-
Find the medium gray Global Processors section just below the Input section.
-
Add Stream sections in the Output sections that are on the appropriate group tab in the very light gray Output Groups section at the bottom of the job.
-
-
Specify values for the image inserter settings. For more information about these specific settings, see the following topics:
-
For information about Start Time, Duration, Fade In, and Fade Out, see Setting Up When Your Overlay Plays.
-
For information about Layer, see Setting Up Overlapping Overlays.
-
