DeleteAccessor - Amazon Managed Blockchain


Deletes an accessor that your AWS account owns. An accessor object is a container that has the information required for token based access to your Ethereum nodes including, the BILLING_TOKEN. After an accessor is deleted, the status of the accessor changes from AVAILABLE to PENDING_DELETION. An accessor in the PENDING_DELETION state can’t be used for new WebSocket requests or HTTP requests. However, WebSocket connections that were initiated while the accessor was in the AVAILABLE state remain open until they expire (up to 2 hours).

Request Syntax

DELETE /accessors/AccessorId HTTP/1.1

URI Request Parameters

The request uses the following URI parameters.


The unique identifier of the accessor.

Length Constraints: Minimum length of 1. Maximum length of 32.

Required: Yes

Request Body

The request does not have a request body.

Response Syntax

HTTP/1.1 200

Response Elements

If the action is successful, the service sends back an HTTP 200 response with an empty HTTP body.


For information about the errors that are common to all actions, see Common Errors.


You don't have sufficient access to perform this action.

HTTP Status Code: 403


The request processing has failed because of an unknown error, exception or failure.

HTTP Status Code: 500


The action or operation requested is invalid. Verify that the action is typed correctly.

HTTP Status Code: 400


A requested resource doesn't exist. It may have been deleted or referenced incorrectly.

HTTP Status Code: 404


The request or operation couldn't be performed because a service is throttling requests. The most common source of throttling errors is creating resources that exceed your service limit for this resource type. Request a limit increase or delete unused resources if possible.

HTTP Status Code: 429

See Also

For more information about using this API in one of the language-specific AWS SDKs, see the following: