AWS Elemental MediaLive
User Guide

Editing an Input

The rules for editing an input are as follows:

  • You can attach a different input security group.

  • For a push input, you can edit the fields in the input destination or endpoint.

  • For a MediaConnect push input, you can edit the ARNs to refer to different MediaConnect flows. The outputs for the former ARNs will be deleted in MediaConnect, and new outputs (with new IDs) for the new ARNs will be created.

  • For a pull input, you can edit the fields in an input source.

  • You cannot change the type of an input. For example, if you set up an input as an RTMP push but it is actually an HLS input, delete the input and create it again.

There are constraints on performing these edits, as follows:

  • If an input is attached to a channel, you can edit the input only if the channel is idle.

  • If an input is attached to a channel and an input security group, you can edit the input only if the channel is idle.

  • If an input is not attached to a channel, you can edit it at any time, even if it is attached to an input security group.

To edit an input

  1. Open the MediaLive console at https://console.aws.amazon.com/medialive/.

  2. In the navigation pane, choose Inputs.

  3. Choose the name of the input, and then choose Edit.

  4. On the Inputs page, make the following changes as appropriate:

    • You can change the Name.

    • You can't change the Input type. If the input has the wrong type, delete it and create it over again.

    • You can change the Source section (applies to "pull" inputs only).

    • You can change the Endpoint section (applies to "push" inputs only).

    • You can change the Input security groups section (applies to "push" inputs only).

  5. Choose Update.

    Wait for the input State to return to In use or Idle before performing another action with this input.