View a markdown version of this page

Optimize and verify HCX migration - Amazon Elastic VMware Service

Optimize and verify HCX migration

After you prepare your Amazon Elastic VMware Service environment, you can turn on optional VMware Hybrid Cloud Extension (HCX) features that improve migration traffic, and then verify HCX connectivity. You do these steps in HCX and NSX, using the Broadcom documentation for each feature.

Before you begin

(Optional) Set up HCX WAN Optimization

If your HCX version includes the HCX WAN Optimization service (HCX-WO), you can use it to improve migration performance over private lines or the internet. HCX-WO applies WAN optimization techniques such as data reduction and WAN path conditioning. It is deployed with the HCX Interconnect (HCX-IX) appliance, which replicates data between your on-premises environment and the Amazon EVS environment.

HCX-WO helps most on deployments that can’t dedicate 10 Gbit paths to migrations. On 10 Gbit, low-latency deployments, it might not improve migration performance.

To use HCX-WO with Amazon EVS, use a distributed port group on the HCX VLAN subnet. Use the port group that you created in Step 5. Create a distributed port group with the HCX uplink VLAN ID.

(Optional) Turn on HCX Mobility Optimized Networking

HCX Mobility Optimized Networking (MON) is a feature of the HCX Network Extension service. MON-enabled network extensions route traffic for migrated VMs within your Amazon EVS environment, instead of on a long round-trip path through the source gateway. This applies when you stretch Layer 2 networks. MON is available for all Amazon EVS deployments.

Before you turn on HCX MON, do the following:

In HCX, turn on MON for the network extension by following Configuring Mobility Optimized Networking in the Broadcom documentation.

Verify HCX connectivity

VMware HCX includes diagnostic tools that test connectivity. To run them, follow VMware HCX Troubleshooting in the Broadcom documentation.

If the checks fail, review the HCX VLAN subnet, network ACL, and route table checks in Prepare for HCX migration. For internet connectivity, also check the Elastic IP address associations in Configure HCX public internet connectivity. For other network issues, see Troubleshoot networking.

You have verified HCX connectivity, and you can start migrating workloads.